Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Requirements:

  • Apple iPad’s for student & teacher

  • A milo robot with power connected.

  • Recommended Internet speed of 5Mb/s or greater.

  • 10/100 Ethernet or 2.4Ghz WiFi connection for robot 

See How-to Connect your Robot to 5GHz WiFi for additional instructions if only 5Ghz WiFi is available.

Network Security Requirements:

  • Tablets & Robots must be able to establish TCP connections on ports 80 and 8080 to *.robokind.us and d23kggeguwanja.cloudfront.net.

Info

If a network firewall is not able to use a wildcard for *.robokind.us, the specific DNS names are: downloads.robokind.us, auth.robokind.us, data.robokind.us, cdn-api.robokind.us, and d23kggeguwanja.cloudfront.net

E-mail requirements:

Unsupported Configurations:

  • Guest WiFi networks

  • WiFi SSID’s that are hidden

  • WiFi SSID’s that have international characters or apostrophe’s

  • Tablets & Robots connected to different WiFi SSID’s.

  • Port Isolation or AP isolation mode on connected switches, routers or Wireless Access Points - these effectively prevent direct communication between the iPad’s and the robots, and will prevent lessons from running.

  • WiFi networks using WEP security (not recommended/supported due to security vulnerabilities)

Info

Some of these configurations may be possible, however given the wide range of networking configurations, RoboKind cannot provide detailed troubleshooting support in these cases.

...

Note

If you get an error message at this step, please see the instructions under How-To Test Robot Network Connectivity to interpret the results.

...

Please test your connection and make note of your IP Address.

How-To Test Robot Network Connectivity

Filter by label (Content by label)
showLabelsfalse
max5
spacescom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@1fb6c1
sortmodified
showSpacefalse
reversetrue
typepage
cqllabel = "network" and type = "page" and space = "CSSD"
labelskb-how-to-article

...